Forums : Operativni sistemi

 Comment
Instalacija XP problem
barbarosa
(ekonomista)
2010-06-03 02:20 PM
do sada sam bezbroj puta vrsio instalaciju sa bootabilnog diska,ali ovaj problem još nisam imao...prilikom pokretanja instalacije,kreće sve u početku kako treba,a onda posle par minuta dolazi do poruke-The file isapnp.sis is corrupted...ja sam mislio da disk nije u redu,pa sam nasao drugi disk,ali sve se opet isto dogadja ili se jednostavno sve ikocu...napominjem da kad hoću da pokrenem safe mod izbaci mi ekran i vrlo brzo opet sve ukoci kod nekog sys fajla vrlo rano...Ima li neko ideju šta može da bude u pitanju i kako da pokusam da resim problem?unapred hvala.
moby
(ELEKTRO)
2010-06-03 02:30 PM
Uvek prvo pitaj google:
http://www.google.com/#hl=en&source=hp&q=isapnp.sis+is+corrupted&btnG=Google+Search&aq=f&aqi=&aql=&oq=&gs_r... &fp=62c7546c9e19fcb7

pa onda redom
http://support.microsoft.com/kb/315311
To resolve this issue, use Recovery Console to replace the Isapnp.sys file.
Back to the top
Windows XP
To replace the Isapnp.sys file in Windows XP, follow these steps:

1. Start the computer from the Windows XP CD-ROM.
2. At the Welcome to Setup screen, press R to start Recovery Console.
3. If you have a dual-boot or a multiple-boot computer, type the number that corresponds to your Windows XP installation when you are prompted to select the Windows installation to log on to, and then press ENTER.
4. When you are prompted for the Administrator password, type the password, and then press ENTER.

Note If the administrator password is blank, just press ENTER.
5. At the C:Windows prompt, type the following command, and then press ENTER:
ren c:windowssystem32driversisapnp.sys isapnp.old
Note The steps in this article assume that you installed Windows XP to the C: drive. The actual location of your Windows installation may vary.
6. At the C:Windows prompt, type the following command, and then press ENTER:
expand cd-romdrive:i386isapnp.sy_ c:windowssystem32driversisapnp.sys
For example, type:
expand d:i386isapnp.sy_ c:windowssystem32drivers
7. After the file is successfully expanded, type exit, and then press ENTER to exit Recovery Console.
8. Restart the computer.

Back to the top
Windows 2000
To replace the Isapnp.sys file in Windows 2000, follow these steps:

1. Start the computer from the Windows 2000 CD-ROM.
2. At the Welcome to Setup screen, press R to repair, and then press C to start Recovery Console.
3. At the C:Winnt prompt, type the following command, and then press ENTER:
expand cd-romdriveletter:i386isapnp.sy_ c:winntsystem32driversisapnp.sys
For example, type:
expand d:i386isapnp.sy_ c:winntsystem32drivers
Note The steps in this article assume that you installed Windows 2000 to the C: drive. The actual location of your Windows installation may vary.
4. After the file is successfully expanded, type exit to exit Recovery Console.
5. Restart the computer.

SM
(System Manager)
2010-06-04 08:34 AM
U kom rezimu je HDD? Ako je SATA HDD treba da bude u IDE mode.
Mostro
(junior member)
2010-06-04 11:07 AM
obrisi windows iz nekog linuksa, pa onda instaliraj.
barbarosa
(ekonomista)
2010-06-04 03:12 PM
videću,ali mislim da nije na SATA režimu...a što se tiče brisanja linuksom,to je već problem pošto se do sada nikad nisam susretao sa linuksom,a Boga mi ni bilo ko koga znam,na žalost...probaću nešto od gorenavedenog,pa ću videti...
zero-col
(programer)
2010-06-11 01:14 AM
Može da bude dosta toga.
Naprimjer prvo cekiraj HDD, možda ima neki BAD Sector na početku diska, pa to koci. Ima onaj Hirrens Boot, disk sa svakakvim programima. Imaš tu opciju da podignes Mini Windows sa diska. E kada to odradis, otvoris command promt i kucas chkdsk c: /f, i chkdsk c: /r
ovim popravljas HDD od bad sektora i nekih sitnih ostecenja.
A linux možeš da podignes sa diska, i preko njega skidas particiju c i windows na njoj.
Polsje svega ovoga uradi instalaciju windowsa, mislim da ćeš uspjeti..

pozz, www.bgdracunari.com
 Comment Remember this topic!

Looking for Mantra Bracelets?
.